viii
Warning labels indicating exposure to laser light and the device classification are
applied onto the body of the scanner (Figure A, 6).
CAUTION - LASER LIGHT WHEN OPEN
AVOID EXPOSURE TO BEAM
LISTED
ACCESSORY
45AF
I.T.E.
This product conforms to the applicable
requirements of 21CFR1040 at the date
of manufacture.
LASER LIGHT
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
MAX. OUTPUT RADIATION 1 mW
EMITTED WAVE LENGTH 630~680 nm
TO IEC 825-1 (1993)
R
U
L
R
U
L
Warning and device class labels
Disconnect the power supply when opening the device during maintenance or
installation to avoid exposure to hazardous laser light.
The laser diode used in this device is classified as a class 3B laser product according
to IEC 825-1 regulations and as a Class IIIb laser product according to CDRH
regulations. As it is not possible to apply a classification label on the laser diode used
in this device, the following label is reproduced on the right.
LASER LIGHT
AVOID EXPOSURE TO BEAM
CLASS 3B LASER PRODUCT
MAX. OUTPUT RADIATION 7 mW
EMITTED WAVE LENGTH 630~680 nm
TO IEC 825-1 (1993)
Laser diode class label
Any violation of the optic parts in particular can cause radiation up to the maximum
level of the laser diode (7 mW at 630 to 680 nm).
To Next Page
Loading...
Need help?
General