DX8200A QUICK GUIDE
17
LASER LIGHT
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
MAXIMUM OUTPUT RADIATION 1 mW
EMITTED WAVELENGTH 630~680 nm
TO EN 60825-1:2001
CAUTION-CLASS 3B LASER LIGHT WHEN OPEN
AVOID EXPOSURE TO BEAM
LASER LIGHT EMITTED
FROM THIS
APERTURE
Model No. Amp.
Serial No.
DATALOGIC S.P.A. Via Candini, 2
40012 Calderara di Reno - Bologna - Italy
Manufactured Volt
This product conforms to the applicable requirements
of 21CFR1040 at the date of manufacture.
Warning and Device Class Labels Device Identification Label
The laser diodes used in this device are classified as Class 3B laser
products according to EN 60825-1 regulations and as Class IIIb
laser products according to CDRH regulations. As it is not possible
to apply a classification label on the laser diodes used in this
device, the following label is reproduced here:
Any violation of the optic parts in particular can cause radiation up
to the maximum level of the laser diode (30 mW at 630~680 nm).
LASER LIGHT
AVOID EXPOSURE TO BEAM
CLASS 3B LASER PRODUCT
MAXIMUM OUTPUT RADIATION 30 mW
EMITTED WAVELENGTH 630~680 nm
TO EN 60825-1 (2001)
Laser Diode Class Label
Power Supply
This product is intended to be installed by Qualified Personnel only.
For DX8200A VDC models:
- This scanner is intended to be supplied by either a UL Listed power supply marked 'Class 2' or 'LPS', output
rated 20 - 30 V dc, minimum 1.75 A or by a UL Listed computer with LPS outputs.
- This scanner must be supplied by a Class II Power Supply Unit conforming to the EN 60950 safety
regulation.
Line Fuse Replacement (VAC Models only)
CAUTION
Caution - double pole/neutral fusing.
For continued protection against risk of fire, replace with same type and rating of fuse (250V,
3.15 A).
WEEE Compliance
To Next Page
Loading...
Need help?
General
Weight and Dimensions
