Programming Barcodes
Quick Reference Guide 11
Programming Barcodes
For your convenience, this guide includes the programming
barcodes required to configure the imager for use with different
interface (terminal/host) types.
See the Product Reference Guide (PRG) for more complete in-
formation about programming and configurable features. You
can download the latest version of the PRG and any other avail-
able publications for the imager from the website listed on the
back cover of this manual.
Resetting the Standard Product
Defaults
If you aren’t sure what programming options are in your imag-
er, or you’ve changed some options and want the factory set-
tings restored, scan the Factory Default Settings barcode below.
This will copy the factory configuration for the currently active
interface to the current configuration.
Factory Default Settings
Some interfaces require the scanner to start in
the disabled state when powered up. If addi-
tional scanner configuration is desired while in
this state, pull the trigger and hold it for five
seconds. The scanner will change to a state that
allows programming with barcodes.
To Next Page
Loading...
Need help?
General
