Datalogic Gryphon i - User Manual

Questions and Answers

W
Wanda CruzAug 1, 2025
What to do if the Datalogic Barcode Reader LED is on, but the barcode does not decode?
- D
  davisdanielAug 1, 2025
  If the LED on your Datalogic Barcode Reader lights up but the barcode isn't decoding, there are a few potential reasons. First, the imager might not be programmed to read that specific type of barcode, so you should ensure it is set up correctly. Secondly, the barcode label itself could be damaged or unreadable, so check for any visible defects and try scanning a different barcode. Finally, the distance between the barcode and the imager could be off, so try moving the imager closer or further away from the barcode.
L
Lorraine DominguezAug 10, 2025
How to fix Datalogic Barcode Reader when barcode is decoded but not transmitted to the host?
- A
  Amber HarveyAug 10, 2025
  If your Datalogic Barcode Reader decodes the barcode but doesn't transmit it to the host, the imager might not be programmed for the correct host type. To resolve this, scan the appropriate host type barcode.
D
Danielle SmithAug 20, 2025
Why nothing happens when I pull the scan button on my Datalogic Barcode Reader?
- A
  Andrew MitchellAug 21, 2025
  If nothing happens when you pull the scan button on your Datalogic Barcode Reader, there are a couple of things to check. First, make sure the imager is receiving power by checking the system power and ensuring the power supply is properly connected. Also, verify that all cable connections are secure, as loose interface or power cables can prevent the device from functioning.