Datalogic GRYPHON USB D Series

To Next Page

To Previous Page

DATALOGIC

DEFAULT VALUES

USB DEFAULT SETTINGS

DATA FORMAT: code identifier disabled, no field adjustment, code length not

transmitted, character replacement disabled.

USB KEYBOARD: USA keyboard, inter-character and inter-code delays

disabled, control character emulation = ctrl+shift+key;

USB COM: no handshaking, delay disabled, rx timeout 5 sec., ack/nack

disabled, FIFO enabled, serial trigger lock disabled;

Default Headers and Terminators for each USB mode:

- USB-KBD: no header, terminator = ENTER

- USB-KBD-ALT-MODE: no header, terminator = CR

- USB-COM: no header, terminator = CR-LF

- USB-IBM-TABLE TOP: not applicable

- USB-IBM-HAND HELD: not applicable

RS232 Standard DEFAULT SETTINGS

9600 baud, no parity, 8 data bits, 1 stop bit, no handshaking, delay disabled, rx

timeout 5 sec., ack/nack disabled, FIFO enabled, serial trigger lock disabled;

DATA FORMAT: code identifier disabled, no field adjustment, code length not

transmitted, no header, terminator = CR-LF, character replacement disabled

RS232 Nixdorf DEFAULT SETTINGS

9600 baud, parity odd, 8 data bits, 1 stop bit, handshaking hardware

(RTS/CTS), delay disabled, rx timeout 9.9 sec., ack/nack disabled, FIFO

enabled, serial trigger lock disabled;

DATA FORMAT: code identifier enabled, no field adjustment, code length not

transmitted, no header, terminator = CR, character replacement disabled

RS232 Fujitsu DEFAULT SETTINGS

9600 baud, no parity, 8 data bits, 1 stop bit, no handshaking, delay disabled, rx

timeout 2 sec., ack/nack disabled, FIFO enabled, serial trigger lock disabled;

DATA FORMAT: code identifier enabled, no field adjustment, code length not

transmitted, no header, terminator = CR, character replacement disabled

RS232 ICL DEFAULT SETTINGS

9600 baud, parity even, 8 data bits, 1 stop bit, handshaking RTS always on,

delay disabled, rx timeout 9.9 sec., ack/nack disabled, FIFO enabled, serial

trigger lock disabled;

DATA FORMAT: code identifier enabled, no field adjustment, code length not

transmitted, no header, terminator = CR, character replacement disabled

Web : http: www.audin.fr - Email : info@audin.fr

Datalogic GRYPHON USB D Series - Default Values