12
MAGELLAN™ 3410VSI
Camera Button
The Camera Button provides the unit with the ability to capture images.
See “Camera Button Mode” on page 18 to enable this feature.
Destination and image type can be specified. Reference the PRG for
additional information and programming options.
Momentary (when
scanner is awake)
Increments volume
Press the button momentarily
to increase speaker volume.
When the loudest volume is
reached, a repeated press of the
button cycles volume back to
the lowest setting, then volume
increases on subsequent
press(es). Five volume levels
are available.
Hold, then release
when the beeper
sounds
Increments tone
Press the button for
approximately 2 seconds, then
release. Each time this is done,
the beeper will sound at one of
three tones. Stop when the
desired tone (high, medium or
low) is sounded.
4 Seconds
Scanner Diagnostics
Mode
a
This mode allows system
support personnel to
troubleshoot problems with the
scanner and is used to
determine if it can read bar
codes. Press the button for 10
seconds or cycle power to exit
Scanner Diagnostics Mode and
reset the scanner.
10 Seconds Resets Scanner
b
Only system support personnel
should perform a reset.
a. By standard default, this function is normally disabled to prevent accidental
activation by users.
b. Users should not perform scanner resets except under the direction of
trained systems support personnel.
PRESS
DURATION
FUNCTION COMMENT
To Next Page
Loading...
Need help?
General
Weight and Dimensions
