Need help?Do you have a question about the Datalogic Laser Sentinel and is the answer not in the manual?
Explains how to configure the device for horizontal safety applications.
Explains how to configure the device for vertical safety applications.
Describes how to use multiple units in a Master/Slave network configuration.
Lists essential precautions to follow during device installation for safe operation.
Details how to calculate minimum safety distances for horizontal setups.
Outlines the basic steps for starting a safety configuration process.
Advises on precautions against environmental factors affecting performance.
Details how to calculate minimum safety distances for vertical setups.
Describes how to connect Master and Slave units in a system.
Describes how to connect Master and Slave units in a system.
Instructions for installing the DLSentinel software on a PC.
Details the steps to install the DLSentinel configuration software.
Explains the two modes for restarting the device after a safety event.
Details settings for response time and scan cycle to ensure safety distance.
Explains the procedure and timing for testing the OSSD outputs.
Explains the override feature to force OSSDs ON for machine restart.
Explains the External Device Monitoring (EDM) function.
Details the use of encoders for dynamic applications and speed measurement.
Explains the Shut Off function for energy saving and device standby.
How to use override function in Stand Alone mode, dependent on muting.
Instructions for enabling and connecting the External Device Monitoring (EDM) function.
How to use override function in Master/Slave systems, dependent on muting.
Step-by-step guide to configure muting using the DLSentinel software.
Allows setting the allowable variation in speed measures from encoders.
Lists and explains various diagnostic fault codes, device status, and OSSD status.
General safety warnings and precautions related to device operation and maintenance.
Procedure for calibrating the new optical window after replacement.
Procedure for quickly replacing components like Master, Slave, or Memory Group.
Procedure for quickly replacing a Slave device.
Procedure for quickly replacing the Memory Group module.
Step-by-step guide for replacing the optical window of the device.
Procedure for quickly replacing the Master device.
Details safety-related data such as integrity level and performance.
To Next Page
General