52
SAFERY LASER SCANNER
CHAPTER 7
LASER SENTINEL SETUP AND
CONFIGURATION
This chapter is dedicated to the Laser Sentinel setup and configuration using the DLSen-
tinel software. The aim of this chapter is t
o guide the user through all the fundamental
procedures of configuring the device.
To employ the safety laser scanner, a safety configuration must be created on DLSenti-
nel, where the user is required to enter all the par
ameters, configure inputs and outputs
and create monitored areas.
For further information about DLSentinel, r
efer to the DLSentinel User’s Manual.
INSTALLING DLSENTINEL GUI
The DLSentinel client application software needs to be installed on your PC to configure
the safety laser scanner.
Minimum System Requirements
To ensure proper interfacing with the system, the personal computer must meet the fol-
lowing minimum requirements:
Processor(s) Pentium 4 Pentium 4
Clock frequency >= 3 GHz >= 2 GHz
RAM 2 GB 1 GB
Free hard drive space 70 MB 70 MB
Monitor resolution 1280x768 1024x768
Supporting Operation System
Windows XP
Windows 7
Windows 8
Windows 10
Besides the components listed in the table above, your PC must be equipped with the
following hardware and software drivers:
• Installed Ethernet network card and installed driver
• One free 100 Mbps Ethernet port
COMPONENT RECOMMENDED MINIMUM
To Next Page
Loading...
Need help?
General