LEDS AND DISPLAY
INSTRUCTION MANUAL
95
LEDs AND DISPLAY
The safety laser scanner is equipped with three lateral buttons, a graphical display and
four status LEDs located below the display.
Diagnostic and Status LEDs
The safety laser scanner has diagnostic LEDs for initial diagnostics.
The OFF state and ON state LEDs can be found below the safety laser scanner display.
When it is not possible to see the display, e.g. due to mounting or because it is hidden
fr
om the operator’s viewpoint, check the GUI status (Monitoring).
LED 1: assigned to safety zone 1 (red indicates object detection in
safety zone 1; green indicates that no presence is detected in
safety zone 1).
LED 2: assigned to safety zone 2 (red indicates object detection in
safety zone 2; green indicates that no presence is detected in
safety zone 2).
LED 3: assigned to safety zone 3 (red indicates object detection in
safety zone 3; green indicates that no presence is detected in
safety zone 3) or warning zone 2 (amber indicates object detection
in warning zone 2, off indicates that no presence is detected in
warning zone 2)
LED 4: assigned to warning zone 1 (amber indicates object detec-
tion in warning zone 1, off i
ndicates that no presence is detected in
warning zone 1)
LED 5: Interlock (amber indicates that the Interlock function is
active).
Button 1: to browse quickly the Menu functions (up).
Button 2: to enter and confirm the selected Menu function.
Button 3: to browse quickly the Menu functions (down).
To Next Page
Loading...
