GETTING STARTED
INSTRUCTION MANUAL
11
GETTING STARTED
Here are the basic steps to start a safety configuration.
• Package Contents: Check that the Laser Sentinel and all parts supplied with the
equipment are present and intact when opening the packaging (refer to
"Package
Contents" on page 3).
• Read all safety information in Chapter 3, Safety Information before proceeding.
• Mechanical Mounting: Laser Sentinel can be installed to operate in different posi-
tions, make sure to follow the exact procedure (refer to Chapter 5, Mechanical
Mounting).
• Electrical Connections: Laser Sentinel must be connected to the application
through the required accessory cables (refer to
Chapter 6, Electrical Connections).
• Software Configuration: Software configuration of Laser Sentinel can be accom-
plished through the Configuration procedure using the DLSentinel GUI (refer to
Chapter 7, Laser Sentinel Setup and Configuration).
PRECAUTIONS FOR ENVIRONMENTAL INTERFERENCE
• The presence of intense electromagnetic interference may affect the correct func-
tioning of the device. This condition shall be carefully evaluated by seeking the
advice of Datalogic Technical Service.
• A sudden change in the environment temperature (e.g. with very low minimum
peaks) can generate a small condensation layer on the laser and compromise
proper operation.
• The operating distance of the device can be reduced in the presence of smog, fog
or airborne dust.
• Installation must be performed by qualified personnel after making sure that the
window is clean and free from scratches, dust, dirt spots and fingerprints. For
more information, refer to
Chapter 10, Device Maintenance.
• Failure to inspect the window or set the proper environmental condition during
installation may lead to a reduced detection capability of the scanner.
To Next Page
Loading...
Need help?
General