Datalogic PowerScan M8300

Charging the Batteries
Quick Reference Guide 5
SETUP
PowerScan
®
M8300/BC-80X0 Point-to Point Configuration
1. Connect an BC-80X0 cradle to the Host. For installation and connection infor-
mation see the BC-80X0 Quick Reference Manual.
2. Charge the PowerScan
®
M8300 battery using an BC-80X0 or the
C-8000 charger as described in this Quick Reference manual. A full charge
takes 4 hours if using an external power supply; while it takes up to 10 hours
if supplying power through the USB port.
3. Configure the reader as described in this Quick Reference -
PowerScan
®
M8300/BC-80X0 Point-to-Point Setup.
4. Configure the BC-80X0 cradle. See BC-80X0 Configuration in the
BC-80X0 Quick Reference.
or
PowerScan
®
M8300/BC-80X0 Stand Alone Configuration
1. Connect an BC-80X0 cradle to the Host. For installation and connection infor-
mation see the BC-80X0 Quick Reference Manual.
2. Charge the PowerScan
®
M8300 battery using an BC-80X0 or the
C-8000 charger as described in this Quick Reference manual. A full charge
takes 4 hours if using an external power supply; while it takes up to 10 hours
if supplying power through the USB port.
3. Configure the reader as described in this Quick Reference -
PowerScan
®
M8300/BC-80X0 Stand Alone Setup.
4. Configure the BC-80X0 cradle. See BC-80X0 Configuration in the
BC-80X0 Quick Reference.
or
PowerScan
®
M8300/STAR-System™ Configuration
1. Charge the PowerScan
®
M8300 battery using an BC-8000 or the
C-8000 charger as described in this Quick Reference manual. A full charge
takes 4 hours if using an external power supply; while it takes up to 10 hours
if supplying power through the USB port.
2. Configure the reader as described in this Quick Reference
PowerScan
®
M8300/STAR-System™ Setup.