Datalogic PowerScan PBT9501-AR - Aztec Code Set Length 2

2D Global Features Enter/Exit Programming Mode
Product Reference Guide 181
Aztec Code Set Length 2
This feature specifies one of the bar code lengths for Aztec Code Length
Control. Length 2 is the maximum label length if in Variable Length Mode,
or the second fixed length if in Fixed Length Mode. Characters can
be set
from 0001 to 3,832 characters in increments of 0001 (pad with zeroes).
See page 290 for detailed instructions on setting this feature.
Select Aztec Code Length 2 Setting
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in
Appendix D, Keypad repre-
senting your desired character(s). End by scanning
the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code t
o abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
Length 2 is 3,832 Characters