Enter/Exit Programming Mode
228
PowerScan™ PD9531-AR/PBT9501-AR/PM9501-AR
Set PIN Code
Determine the desired characters for the PIN code, then convert to hexadec-
imal using the ASCII Chart on the inside back cove
r of this manual. See
page 306 for detailed information and examples for setting this feature.
Set 4-character Bluetooth PIN Code
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the hexadecimal digits from
the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
Set 16-character Bluetooth PIN Code
CANCEL
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
31323334 = Default PIN Code is 1234
To Next Page
Loading...
