Enter/Exit Programming Mode
258
PowerScan™ PD9531-AR/PBT9501-AR/PM9501-AR
ACTION CONFIGURATION FOR FUNCTION KEYS
Configure actions (up to three) for the function keys
Configure Actions for F1
F1 No Actions Configured
Configures Action for F1
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code for the Function Key you want to program. Next
scan 4 digits from the Alphanumeric characters in
Appendix D, Keypad
.
The first digit must be 0; the following 3 digits must
be confi
gured according to the CMD_ID numbers in
Table 27 on page 257
. End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
an
d not save the entry string. You can then start
again at the beginning.
CANCEL
To Next Page
Loading...
