Set Date and Time
8PowerScan™ PBT9501
Set Date and Time
1. Scan the Enter/Exit Programming barcode
below to set date and time.
ENTER/EXIT PROGRAMMING MODE
2. Scan the Set Date barcode + six digits for Year,
Month and Day (YYMMDD) from the Hex-
Numeric Keypad on page 33.
Set Date
3. Scan Set Time + six digits for Hours, Minutes and
Seconds (HHMMSS) from the Hex-Numeric Key-
pad on page 33.
Set Time
4. Scan the Enter/Exit Programming barcode to
complete.
NOTE
Factory defaults are based on the interface
type. Be sure your reader is configured for the
correct interface before scanning this label.
To Next Page
Loading...
