Indicators
Quick Reference Guide 5
Successful reading is signaled by an audible tone plus a good-read green
LED.
Indicators
LED Indicators
The PowerScan™ PD8530 family uses green LED indicators to signal
the following reader functions:
Beeper
The PowerScan™ PD8530 basic software provides beeper signals for
good/wrong reading and for indicating errors. Its tone, volume and dura-
tion can be directly configured by using the codes given in the Power-
Scan™ PD8530 Product Reference Guide (PRG) available on the
website.
The application program can also manage the beeper (User Defined
Beeper) when the reader is controlled by a Host PC. It is possible to acti-
vate the beeper by sending a command from the Host to the reader via the
current communication interface.
The PowerScan™ PD8530 hand-held reader aiming system is
designed for general reading and decoding of 1D and 2D
symbols. Some variation in reading distance will occur due
to narrow bar width and other factors.
If reading codes positioned on reflective surfaces, it may be
necessary to tilt the reader with respect to the barcode and/
or set the Camera Control parameters. For configuring the
Camera Control parameters refer to the PowerScan™
PD8530 Product Reference Guide (PRG) available on the
website and the CD.
STATUS BEHAVIOR
Power ON
At power-on, the LEDs blink briefly, then
light up for 2 seconds to signal the power
supply is present.
Normal Function
The LED lights up after a good decoding
and will switch off only at the next trigger
press.
To Next Page
Loading...
Need help?
General
