Datalogic PowerScan PD9530

Reading Parameters
20 PowerScan™ PD9530
Reading Parameters
Move the reader toward the target and center the aiming pat-
tern and illumination system to capture and decode the image.
See Using the PowerScan™ PD9530 on page 8 for more informa-
tion.
The aiming system will briefly switch off after the acquisition
time, and if no code is decoded will switch on again before the
next acquisition. The illuminator will remain on until the
symbol is decoded.
As you read code symbols, adjust the distance at which you are
holding the reader.
Good Read Green Spot Duration
Successful reading can be signaled by a good read green spot.
Use the bar codes that follow to specify the duration of the
good read pointer beam after a good read.
ENTER/EXIT PROGRAMMING MODE
Disabled
Short (300 ms)
Medium (500 ms)
Long (800 ms)