Datalogic PowerScan PD9530

Operating Modes
22 PowerScan™ PD9530
Scan Mode (continued)
Motion Aiming Control
This feature configures the ability of the scanner to Enable/
Disable the Aiming system when motion is detected. Scan the
Enter/Exit Programming bar code above, then either of the
barcodes below.
ENTER/EXIT PROGRAMMING MODE
 Scan Mode = Trigger Single
Scan Mode = Trigger Pulse Multiple
Scan Mode = Trigger Hold Multiple
Scan Mode = Flashing
Scan Mode = Always On
Scan Mode = Stand Mode
 Motion Aiming Control = Enable
Motion Aiming Control = Disable