Reading Parameters
Quick Reference Guide 15
Reading Parameters
Move the reader toward the target and center the aiming
and illumination system to capture and decode the image.
See Using the PowerScan™ PD9531-AR on page 3 for more
information.
The aiming system will briefly switch off after the acquisi-
tion time, and if no code is decoded will switch on again
before the next acquisition. The illuminator will remain on
until the symbol is decoded.
As you read code symbols, adjust the distance at which
you are holding the reader.
Good Read Green Spot Duration
Successful reading can be signaled by a good read green
spot. Use the 2D codes that follow to specify the duration
of the good read pointer beam after a good read.
ENTER/EXIT PROGRAMMING MODE
Disabled
Short (300 ms)
Medium (500 ms)
Long (800 ms)
To Next Page
Loading...
