Datalogic PowerScan PM9100 Series User Manual

Installing the Battery Pack
6 PowerScan™ PBT9500-HP-E
Charging the Batteries
Once the BC 90x0-BT is powered, you can charge the
reader's batteries. Place the PowerScan
™
PBT9500-HP-E
into the BC 90x0-BT cradle. The Reader LED on the cradle/
battery charger turns red.
The battery is completely charged when the Reader LED
on the cradle/battery charger turns green.
The battery can also be charged in the spare battery slot
(BC91xx models only) or using the Multi Battery Charger
accessory.
Changing the Batteries
1. Push the button at the bottom of the handle as
shown to release the battery.
2. Pull down to remove the battery.
Button
1
2

Datalogic PowerScan PM9100 Series Specifications

General

Brand	Datalogic
Model	PowerScan PM9100 Series
Category	Barcode Reader
Language	English