Installing the Battery Pack
Quick Reference Guide 7
Charging the Batteries
Once the BC 90x0 is powered, you can charge the reader's
batteries. Place the PowerScan
™
PM9100 into the BC 90x0
cradle. The Reader LED on the cradle/battery charger
turns red. The battery is completely charged when the
Reader LED on the cradle/battery charger turns green.
The battery can also be charged in the spare battery slot
(BC91xx models only) or using the Multi Battery Charger
accessory.
Changing the Batteries
1. Push the button at the bottom of the handle as
shown to release the battery.
2. Pull down to remove the battery.
Do not incinerate, disassemble, short termi-
nals or expose to high temperature at risk of
fire, explosion. Use specified charger only.
Risk of explosion if the battery is replaced by
incorrect type. Dispose of batteries as
required by the relevant laws in force.
WARNING
To Next Page
Loading...
