LED and Beeper Indications
38 QuickScan™ QBT2400
LED and Beeper Indications
The reader’s beeper sounds and its LED illuminates to indi-
cate various functions or errors on the reader. An optional
“Green Spot” also performs useful functions. The following
tables list these indications. One exception to the behaviors
listed in the tables is that the reader’s functions are program-
mable, and so may or may not be turned on. For example, cer-
tain indications such as the power-up beep can be disabled
using programming bar code labels.
Indication Description LED Beeper
Power-up
Beep
The reader is in the
process of power-
ing-up.
N/A
Reader beeps
four times at
highest fre-
quency and vol-
ume upon
power-up.
Good Read
Beep
A label has been
successfully
scanned by the
reader.
LED behavior for
this indication is
configurable via
the feature “Good
Read: When to
Indicate” (see the
PRG for informa-
tion.)
The reader will
beep once at cur-
rent frequency,
volume, mono/
bi-tonal setting
and duration
upon a success-
ful label scan.
ROM Failure
There is an error in
the reader's soft-
ware/program-
ming
Flashes
Reader sounds
one error beep at
highest volume.
Limited
Scanning
Label Read
Indicates that a
host connection is
not established
when the IBM or
USB interface is
enabled.
N/A
Reader 'chirps' six
times at the
highest fre-
quency and cur-
rent volume.
Reader
Active Mode
The reader is
active and ready to
scan.
The LED is lit
steadily
a
N/A
Reader
Disabled
The reader has
been disabled by
the host.
The LED blinks
continuously
N/A
To Next Page
Loading...
