Datalogic QuickScan i QD2100 Product Reference Guide

Resetting the Standard Product Defaults
Product Reference Guide 9
Resetting the Standard Product Defaults
If you aren’t sure what programming options are in your imager, or you’ve changed some
options and want the factory settings restored, scan the
Standard Product Default Set-
tings
barcode below. This will copy the factory configuration for the currently active in-
terface to the current configuration.
The programming section lists the factory default settings for each of the menu com-
mands (indicated by shaded blocks and bold text) on the following pages.
NOTE
Factory defaults are based on the interface type. Configure the
imager for the correct interface before scanning this label.
Standard Product Default Settings

Datalogic QuickScan i QD2100 Specifications

General

Scan speed	8 sec/page
Wavelength	610 nm
Tilt angle range	-65 - 65 °
Decoding standards	1D / GS1 DataBar China Post GS1 DataBar Expanded/ Stacked/ Stacked Omnidirectional
Dimensions (WxDxH)	170 x 66 x 71 mm
Standard interfaces	RS-232, USB, Keyboard wedge
Input voltage	5 V
Power consumption	340 mA
Product color	White
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	5 - 95 %

Weight and Dimensions

Weight	121.9 g