Advanced Data Formatting Guide 9
Chapter 3
Special Commands
Pause Duration
This parameter along with "Send Pause" on page 28 allows a pause to be inserted in
the data transmission. Pauses are set by scanning a two-digit number (i.e., two barcodes),
and are measured in 0.1 second intervals. For example, scanning barcodes “0” and “1”
inserts a 0.1 second pause; “0” and “5” gives a 0.5 second delay. Numeric barcodes begin
on page 86 in the chapter, Alphanumeric Keyboard. In case of an error, or to change
the selection, scan Cancel on page 22.
Pause Duration
Begin New Rule
Scan this barcode to start entering a new rule
Begin New Rule
Save Rule
Scan this barcode to save the entered rule.
Save Rule
To Next Page
Loading...
Need help?
General
