Datalogic QuickScan QS6500 Quick Reference Guide

Quick Reference Guide 3
Troubleshooting
If the linear imager is not operating properly, the following checks
should be performed:
1. Since the linear imager can receive its power from the host
computer (Power Off the Terminal—P.O.T.), it will not
operate without the system power on. If the linear imager
uses an external power supply and the external power supply
has failed, the linear imager will not operate.
2. If an external power supply is used, exchange the power sup-
ply with a known good power supply and retest the linear
imager.
3. If the linear imager receives power from the host (P.O.T.),
connect the linear imager to a known good host and retest.
4. Verify that the interface cable is securely attached to the host.
Consult your technical support personnel or refer to your
host system manual to verify the proper connection for the
linear imager.
5. Verify that the interface cable is securely attached to the lin-
ear imager.
6. Check that the labels are of sufficient quality to be recog-
nized by the linear imager. Wrinkled, smudged, or torn
labels can cause the linear imager to not read at all. Scan a
known good label to check the linear imager's read opera
-
tion.
OFF
ON
1
2
3

Datalogic QuickScan QS6500 Specifications

General

Scan speed	450 sec/page
Tilt angle range	-60 - 60 °
Maximum scan area	610 mm
Decoding standards	- 1D - Code 16K - EAN/JAN - GS1 DataBar - PDF Models - GS1 DataBar Expanded Stacked - GS1 DataBar Stacked - GS1 DataBar Stacked Omnidirectional - MicroPDF417 - PDF417 - UPC A/E
Dimensions (WxDxH)	165 x 74 x 99 mm
Cable length	2.44 m
Standard interfaces	Keyboard wedge
Input voltage	4.5 - 14 V
Power consumption	300 mA
Certification	RoHS
Product color	Black
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	5 - 95 %

Weight and Dimensions

Weight	181.4 g