About the Scanner
4
QUICKSCAN™ 2500
End-Cap Cover
End-cap cover disassembly procedure
1. Using a small screwdriver or a similar tool pull out the
End-Cap from the scanner plastic enclosure.
2. Sequence of extraction of the End-Cap.
3. The End-Cap is completely removed from the scanner.
NOTE: For QuickScan™ QD2500, to use the Stand
Autosense™ (STD-AUTO-QD25-xx) it is manda-
tory to remove the End-cap. See the paragraph
below.
To Next Page
Loading...
