RAPID CONFIGURATION
7 SMART-VS
Firmware Rollback and Reset Configurations (optional)
It is possible to perform a firmware Rollback to the second to last software version
installed or a complete Reset Configurations.
In order to perform the Rollback or Reset procedure, follow the next steps:
1. Disconnect the device power supply.
2. Press and hold down the HMI button.
3. Power up the device keeping the HMI button pressed until:
• for firmware Rollback, hold down until all LEDs blink simultaneously, then release
it when they are steady on (within 4 seconds max).
• for the Reset configurations procedure, hold down until all LEDs blink simulta-
neously, then release and press it again (within 1 second).
NOTE: It is suggested to close the Smart-VS WebApp before performing the
procedures above. Connect to or refresh the WebApp to check the device
software version (see "
Utilities" on page 15).
NOTE: All saved jobs are kept with a Firmware Rollback. Two consecutive
Firmware Rollback procedures lead to the factory software version keep-
ing all the saved jobs.
NOTE: The Reset Configurations procedure restores the factory default
configurations (global settings and IP address 192.168.3.100) and erases
all saved jobs, while keeping the last software version installed on your
device.
To Next Page
Loading...
