To Next PageTo Next PageTo Previous PageTo Previous Page
How to fix unacceptable print quality on Datamax Label Maker?
To address unacceptable print quality on your Datamax Label Maker, start by cleaning the printhead. If the issue persists, the printhead temperature might be too high; adjust the burn time or heat setting using the software control. Also, ensure you are using the correct ribbon type for your labels.
What to do if Datamax Allegro 2 does not print or prints multiple labels?
If your Datamax Label Maker isn't printing or prints multiple labels at once, the labels might be loaded incorrectly. Refer to the loading instructions. The media sensor might be out of adjustment or defective, in that case you should call for service.
Why does the ribbon not advance on my Datamax Label Maker?
General| Print Resolution | 203 dpi |
|---|---|
| Print Speed | 6 inches per second |
| Connectivity | USB, Serial, Ethernet |
| Supported Media Types | Labels, Tags |
| Media Width Range | 1 inch to 4.25 inches |
| Power Requirements | 100-240 VAC, 50-60 Hz |
