Getting Started
8 Allegro2
1.4 Media Installation
Installation
The Printer is designed for easy label stock and ribbon installation.
A diagram located under the cover of the Printer shows the feed
path for print media. Simply lift the cover of the Printer from the
right-hand side to locate the installation instructions.
Figure 1-6 Label Loading Diagram
Labels
The Printer uses labels up to 4.65" (118mm) wide. The maximum
diameter of a roll of labels used in the Printer is 8" (203mm). If a
label is narrower than 3.5" (89mm) then the Printhead must be
adjusted off the roller. Please refer to Section 4.2.2, “Adjusting
Printhead Pressure and Support,” for more information.
To Next Page
Loading...
