Creating Labels Using Internal Batch Software
Allegro2 37
F6 and ALT-P: While in the far left position of the Create/Modify
Label Screen or the Sample: position of the Print Label
Screen, press ALT-P to bring up the Print Parameters
Windows. It will look like this:
PRINT ADJUSTMENTS
HEAT FACTOR: 10
PRINT SPEED: C
SLEW SPEED: C
DOT PATTERN (5 mil): 1 X 1
LABEL ADVANCE: 02.20
FORM EDGE OFFSET: 02.20
ROW OFFSET: 00.00
COLUMN OFFSET: 00.00
COUNT BY: 01
MAX. LABEL WIDTH: 04.10
MAX. LABEL LENGTH: 12.00
CONTINUOUS FORMS: NO
ACTIVE BUFFERS (1/2) 01
CUT BY (# PER CUT): 0001
SENSOR TYPE: EDGE
EDGE?REFLECTIVE E
Figure 3-1 ALT-P Screen
Print parameters include row and column offsets, form edge offset,
label advance, dot size, heat setting, etc. Use the arrow keys to move
from one position to the next. Key in any values that need to be
changed. Press the Esc key to exit the window. A description of
each print parameter along with default values and valid settings are
listed in Table 3-2.
To Next Page
Need help?
General
