Datamax DMX E E-4204 - 4.6 Internal Labels; 5.6 Darkness Adjustment; 5.7 Resetting to Factory Defaults; 5.8 Downloading Firmware and Fonts

E-4203/E-4204/E-4304 37
; Note: If you wish to discard the changes and revert back to the
previous calibration simply turn off the printer before Step 7.
7. Now save the changes and resume by pressing the
+
buttons simultaneously and briefly. Wait until the PAUSED
Light goes off.
4.7 Internal Labels
The following section details the printer’s internally generated
configuration and test labels.
4.7.1 Database Configuration and Dot Check Labels
The Database Configuration Label provides valuable printer information
including the firmware version, memory allocations, enabled options, and
label-counter data.
To print the Database Configuration and Dot Check Labels:
With the printer on, loaded with media (at least 4 inches wide) and ribbon
(if printing with thermal transfer media), press the
+
buttons
simultaneously.
The first label printed will be the Database Configuration Label.