48 E-4203/E-4204/E-4304
3. The PAUSED Light will flash during the download.
4. Following a successful download, the PAUSED Light will
illuminate then the printer will perform a ‘cold reset.’ The previous
printer setup will not be affected unless substantial firmware data
structure changes have occurred. Print a Database Configuration
Label to verify your new firmware version.
¾ Following an unsuccessful download, the FAULT Light will
illuminate then the printer will perform a ‘warm reset’ (both the
POWER and PAUSED Light will be on during power-up
initialization). The original firmware will remain operational. If
the printer fails to reset, toggle the power ‘Off’ and ‘On.’
Try re-sending the file to the printer. If the failure continues,
check the following possible causes:
An invalid or corrupted file is being downloaded - Ensure the
file being downloaded is correct and applicable for your
printer model.
Possible communications error - Check the cable connection
between the host and printer and ensure that a quality,
shielded cable is used.
Possible Flash memory problem - Call for service.
If the printer fails to boot-up after an unsuccessful download, turn
‘Off’ the power. Simultaneously press and hold the F1 and F3
buttons while powering ‘On’ the printer. Now, try downloading
the file to the printer.
To Next Page
Loading...
Need help?
General