Datamax E-Class Mark III Quick Start Guide

1
Paper Menu
92-2604-01 Rev.C
Paper Menu Introduction
The Paper Menu is a feature that allows the operator to change the printer’s settings without the need of a
host computer or additional software. This document explains how to use the internal Paper Menu and
change the printer settings.
Requirements:
 Basic or Advanced E-Class Mark III printer.
 Firmware version 14.134 or greater or printer Serial# 4xxxxxxx or greater.
 Printer loaded with full width media, at least 4” (102mm) wide.
Accessing the Paper Menu
There are two ways to access the Paper Menu, depending on the state of the printer. The illustrations
below show the sequence of steps for when the printer is already on and when the printer is off. The left
LED blinks green at a 1 second interval once the Paper Menu has been accessed.
From the Power Off State:
Printer is OFF
Green, Off
Press and hold
Both Flashing
Release Button
Enter
Paper Menu
Selection Mode
Green, Slow Blink
Turn On
initializing

Datamax E-Class Mark III Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Resolution	203 dpi (8 dots/mm)
Print Speed	Up to 6 ips
Max Print Width	4.25 inches
Media Sensor	Reflective and Transmissive
Interfaces	USB, Serial
Media Types	Labels, Tags, Wristbands
Media Width	0.75 in to 4.65 in
Media Thickness	0.0025 in to 0.0100 in