B-2
1. After installation, from the Windows Start Menu, navigate to Programs>Imaje NetCenter and launch the program.
The application will search for installed printers and display them in the following window
2. Verify the printer has obtained a valid IP address for your network. If the printer was not found or if a valid IP
address was not obtained, you must use the Configuration via Serial Port procedure.
When multiple printers are displayed, match the MAC address located on the printer’s serial label
(located on the rear of the printer) with the MAC address displayed in the NetCenter window.
Once the previous steps have been successfully completed you may now use the IP Address to:
> Install a printer driver, and start printing from your Windows
®
applications. The driver is located on the “Accessories CD-
ROM” (shipped with the printer).
-or-
> Browse to the printer’s internal web pages for advanced wired configuration or to enable and configure a wireless
connection. See section, Printer’s Internal Web Pages.
To Next Page
Loading...
Need help?
General