To Next Page

To Previous Page

6. Operation

6.4 Adjusting the Print Head

Adjusting Print Head Position

Note:

These adjustments are only

necessary when changing to media

with different thickness or width. The

pictures shown describe an MP

Nova4 DT. The process works the

same for all MP Nova printers.

Changing the position of the

adjustment screws can be necessary

if the labels are very narrow

Check that the printer is turned

off. Open the cover and fold the

handle.

Loosen the upper nut of the

adjustment screw you want to

move by turning it counter-

clockwise.

Slide the adjustment screw into a

new position and tighten the upper

nut. Pull the handle if sliding the

adjustment screw past the finger

nut.

Note: When tightening the upper

nut. Make sure it is pressing the

sliding rail against the bottom of

the notch and not against the

lower nut.

The adjustment screws should

make the print head press evenly

onto the media. Make test prints

to find the correct positions.

Datamax MP-Nova4 DT User Manual

Questions and Answers: