34
9. Firmware Update
1) Copy two image files, p200mcpu.bin and p200mctl.bin, into the root
directory of a USB hard drive (<16 GB) and insert it into the USB port of
the PTC-200/PTC-200W (You may also use USB extension cord).
2) Open the operation menu using the IR remote controller (select from
CAM 1-4; default is CAM1)
3) Main Menu
=> 5: SYSYEM
=> 5: UPDATE SOFTWARE
=> 4: UPDATE ALL
=>YES
=> ENTER
4) Wait for another five minutes until the following lines appear on the
screen
- Updated Mot-BD => OK.
- Updated MCPU => OK.
The OSD will flash “Write OK/Power ON Again” alternately; it takes
approximately 5-7 minutes to complete the update.
5) Turn off the device by unplugging the power cord and plug the power
cord back into the socket to turn on the device again.
6) FW Update is complete as soon as the device is booted up.
To Next Page
Loading...
