7 WORKING OF THE MACHINE
7.1 Taking use of the machine
Check if the machine is placed correctly as described in chapter 6 “Installation”.
Check if it is necessary to clean the machine because of possible transport dirt.
In the factory, the dividing disc is lightly greased. Clean the dividing disc before you start working with
dough and then oil it with a little bit of edible oil (see chapter 9 “Maintenance”).
Also check if the voltage on the machine plate is in accordance with that of your main supply.
Make sure the machine is placed on a solid and flat floor.
Check the direction of rotation of the machine. Turn the power switch to position 1 and press the
rounding handle. The rounding table will make a rotation movement counterclockwise. If this is not
the case, an electrician should change the two phases in the plug in order to change the direction of
rotation of the motor.
You can now proceed with the first test.
To Next Page
Loading...
