DBL Technology EP-636 - Lcd Contrast; Reset Config; Device Config; Voice Mail

DBL Technology EP-636 User Manual
4.2.3.4 LCD CONTRAST
There are four levels for you to adjust from“*”to “****”by using .
4.2.3.5 RESET CONFIG
Select “4” to see the “RESET CONFIG” menu. You need to input login ID and password. This
will reset the internal settings to their default values. Refer to the default setting for the default
values. The following parameters will only be affected.
1) LAN Port
2) PC Port
3) Gateway Address
4) Primary and Secondary DNSs
5) Time Zone
6) Endpoint Mode
7) H.235 Authentication
8) Firewall
9) Codec Preference
10) FastStart
11) Network Tones
12) Dialup Network
13) DHCP Service
14) On-line upgrade
4.2.4 DEVICE CONFIG
Select “4. DEVICE CONFIG” in “MENU” list. You need to input “LODGIN” ID and
“PASSWORD” in order to configure the device by menu mode. The ID for user is “user” and the
password is “1234”. The ID for administrator is “admin” and the password is “dbl#admin”.
4.2.5 VOICE MAIL
Select “5. VOICE MAIL” in “MENU” list. And then press “OK” to start this function.
•
20