S5750E Series Installation Guide Chapter 2 Device Installation
2-3
2.3.3 SFP/SFP+ Transceiver Installation
Switch has multiple 10Gb interfaces and provides multiple 10Gb SFP/SFP+ transceiver
slots.
The procedure for installing the SFP/SFP+ transceiver is shown below:
Step 1: Put on a ESD wrist strap (or antistatic gloves)
Step 2: Insert the SFP/SFP+ transceiver to the guide rail inside the fiber interface line card.
Do not put the SFP/SFP+ transceiver up-side-down.
Step 3: Push the SFP/SFP+ transceiver along the guide rail gently until you feel the
transceiver snap into place at the bottom of the line card.
Note: the SFP/SFP+ transceiver is hot swappable.
Caution!
Do not stare directly at the 2 fiber bore in the SFP/SFP+ transceiver when the switch is in
operation, otherwise the laser may hurt your eyes.
2.3.4 Copper Cable/Fiber Cable Connection
Copper cables should be connected as below:
Step 1: Insert one end of the Ethernet cable to the RJ-45 Ethernet port in the switch
copper cable line card;
Step 2: Insert the other end of the Ethernet cable to the RJ-45 Ethernet port of some other
device;
Step 3: Check all status indicators for the corresponding ports; a lighted LED indicates that
the link has been established, otherwise the link is not ready and the cable should be
examined.
Caution!
Please verify the sign above the port to ensure using the right port. Connecting to wrong
ports might damage the switch.
Fiber cables should be connected as below:
Step 1: remove the protective plug from the SFP/SFP+ fiber transceiver bore; Remove the
protective cap from one end of the fiber cable. Keep the fiber end clean and neat.
Step 2: Attach one end of the fiber cable to the SFP/SFP+ transceiver, and attach the
other end to the transceiver of the other devices. Note: SFP/SFP+ transceiver’s TX port
should be connected to RX port of other device, and SFP/SFP+ transceiver’s RX port
should be connected to TX port of other device.
Step 3: Check the fiber port status indicator, a light LED indicates that the link has been
established; otherwise the link is not ready and should be examined.
To Next Page
Loading...
Need help?
General
