To Previous Page

S5750E Series Installation Guide Chapter 2 Device Installation

2-5

3. Installation steps:

Step 1: Ensure the power switch is set to the off position.

Step 2: Use the screwdriver to turn the screws on the earth ground screw point.

Step 3: Strip one end of the ground wire to the ground hole of system.

Step 4: Connect the other end of the ground wire to a suitable grounding point of building

at your side.

Questions and Answers:

Need help?

Do you have a question about the DCN S5750E Series and is the answer not in the manual?

DCN S5750E Series Specifications

General