- 53 -
features. Click " Edit " in the operation column to modify the radio settings,
including status, channel, channel bandwidth, transmit power, multicast rate, STBC
mode, Beacon interval, DTIM period, RTS period, max clients, etc., as shown below:
5.6 DHCP Server
DHCP refers to the Dynamic Host Control Protocol. The WL8200-T3 (IT3) has a
built-in DHCP server that can automatically assign IP addresses to computers in the
local area network. It is not easy for users to configure TCP / IP protocol parameters
for all computers in the local area network. It includes IP address, subnet mask,
gateway, DNS server, etc. The DHCP service can solve these problems.
5.6.1 DHCP Server
Click "DHCP Server">> "DHCP Server" on the left menu to set the DHCP server
parameters. As shown below:
To Next Page
Loading...
