SI-3
™
User’s Manual
5
About This Manual
This manual contains valuable information to help you set up, use
and maintain your radar, so you can optimize its life and keep it at
peak performance. Please take a moment to read through it, and
keep it handy for future reference.
Note the following symbols in this manual:
Indicates a warning message about safety
precautions. Please read it carefully.
Indicates a helpful tip or precaution to note.
1. Safety Information
All service needs should be referred back to the manufacturer.
WARNINGS
• Do not over voltage the radar - it can damage the unit!
• The SI-3™ is designed to operate o of conventional
+12 VDC (+10.8 to +16.5 VDC) from the serial cable.
Important Warnings
• Opening the SI-3™ automatically voids any warranty
still in eect. There are no user serviceable parts inside.
• Do not expose the SI-3™ to excessive moisture. Never
submerge the device.
• Do not drop the SI-3™ on hard surfaces since damage
could occur. Units damaged by dropping or abuse are
not covered for warranty repair.
Violation of these guidelines may void the warranty.
To Next Page
Loading...
