Delfi DelfiScan C51 - Page 43

DelfiScan
Programming Manual
Configure Your DelfiScan
39
PROGR
AM
Operation Control
Time-out Setting, Good Read Beep Duration
M_DEF
AULT
Family Code Selection P.C Parameter Selection Option Code
Auto Power Off Duration
SS
SS
SS
SS
Short
Medium
Long
Extremely long
0
1
2
3
Hands Free Time-out
SS
SS
SS
SS
Short
Medium
Long
Extremely long
0
1
2
3
Good Read Duration
SS
SS
SS
SS
Short
Medium
Long
Extremely long
0
1
2
3
Time Delay to Low Power
Mode
SS
SS
SS
SS
SS
1 sec
3 secs
5 secs
7 secs
9 secs
0
1
2
3
4

The
Auto Power Off Duration
is a pre-defined power off time out counter for Alternative Mode, Presentati
on Mode and Flash Mode. The scanner
keeps th
e light source on till the pre-defined auto power off duration is up. You can adjust this parameter to meet your own application requ
irement.

The
Presentation Mode, Force Mode and Flash Mode are referred to as “hands free” modes. The hands free mode will be automatically chan
ged to
manual trigger mode if you remove t
he imager from stand. The manual trigger mode will be changed to hands free mode if you place the imag
er back
to stand. You can set the time for imager to remain in manual trigger mode by setting the
Hands Free Time-Out
. Once the time-out value is up (if
ther
e have been no further trigger pulls), the imager reverts to the original hands free
mode.

The
Time Delay to Low Po
wer Mode
sets the time for scanner to enter low power mode after any scanning activity when the scanner is in th
e Low
Pow
er Mode
.