Section 3 Operation
Part Number: 9291545 REV00 11/20 15
CHANGING DISPLAY FROM FAHRENHEIT TO CELSIUS ON
ERC112 CONTROL
1. Simultaneously hold the up and down arrows for
5 seconds to access menu for password protected
parameters.
2. Screen should temporarily flash PAS and then move to a
numeric screen.
3. Scroll to 187 using the up/down arrows and push the
stand-by button (lower left button) to enter.
4. Scroll to dis using the up/down arrows and push the
stand-by button (lower left button) to enter into the
display menu.
5. Scroll to CFu using the up/down arrows and push the
stand-by button (lower left button) to enter the display
unit menu.
6. -F should be displayed indicating Fahrenheit. Use the
down arrow to change it to -C for Celsius and hit the
stand-by button (lower left button) to enter the change.
7. Push the defrost button (upper left button) to move out
of the display unit menu.
8. Push the defrost button (upper left button) to move out
of the display menu and back to the normal display.
NOTE: For steps 7 and 8, display will return back to normal
display after 30 seconds of inactivity.
To Next Page
Loading...
Need help?
General
