Dell EMC DP5300 - Avamar Frus; Replace an Avamar Ethernet Cable

Avamar FRUs
Replacement procedures for the Avamar Data Store Gen4T are available from the
Solutions Generator in Solve Desktop.
Replace an Avamar Ethernet cable
Complete the following steps to replace an Ethernet cable on an Avamar server.
Note
This procedure is only for the twinax cables connecting the Avamar server to the Dell
switch. FRU replacement of the cables connected to the Brocade switches is not
supported.
Procedure
1. Disconnect the failed cable from the switch.
2. Disconnect the failed cable from the Avamar server.
3. Connect the new cable to the switch.
4. Connect the new cable to the Avamar server.
Avamar FRUs
DELL EMC CONFIDENTIAL
28 Integrated Data Protection Appliance (IDPA) 2.1 Field Replacement Guide