5. Attach the switch to the two-post rack using two number 12-24 screws on each side.
To uninstall the switch from the rack, unscrew the four number 12-24 rackmount screws.
Wall- or ceiling-mount switch installation
This installation procedure is for the full-width N2200-ON Series switches only.
NOTE: To install an external power supply, see the
External Power Supply (EPS) Installation for the Dell EMC
PowerSwitch N2200-ON and N3200-ON Series Switches
at www.dell.com/support.
You must order the mounting supplies for this installation separately. You need a drill and a pencil to complete this procedure.
1. Remove the four wall- or ceiling-mount brackets, wall anchors, and screws.
2. Screw two brackets to the left side of the switch using two screws for each bracket.
Torque the screws to 10 in-lbs.
3. Repeat to attach two brackets to the right side of the switch.
4. Hold the wall- or ceiling-mount template to the wall or ceiling. Mark the screw-hole locations on the wall with the pencil.
Wall- or ceiling-mount dimensions
24
N2200-ON Series switch installation
To Next Page
Loading...
