Dell 1320c - Color Laser Printer - Using the Output Tray Extension


2. After the even pages have finished printing out, stack the prints and turn the stack over.

3. Next print the odd pages. One sheet at a time, set the very top print that was turned over as it is with the blank side face down, then press the
Continue button. Print pages in the order page 1 (rear of page 2), page 3 (rear of page 4), then page 5 (rear of page 6).
Example: When duplex printing a four page document onto two sheets.
Set one page at a time in the manual feed tray in the order page 2 (rear) ® page 4 (rear) ® page 1 (front) ® page 3 (front).
Using the Output Tray

The output tray holds up to:

l 150 sheets of plain paper
Using the Output Tray Extension

The output tray extension is designed to prevent print media from falling from the printer after the print job is complete.

Before printing a document, ensure that the output tray extension is fully extended.

back to contents page
NOTE: Warped or curled prints can cause paper jams. Straighten them before setting them.
NOTE: Printing on both sides of the paper is not possible if the document consists of various sizes of papers.