Machine Check
Purpose:
To check the mechanical operations of the printer.
Values:
Paper Wrinkle Check Mode
Purpose:
To determine whether or not paper is wrinkled in the fuser.
This function stops printing before the paper enters the fuser. After you remove the paper inside the printer, check the following:
l If the paper is wrinkled, the wrinkle occurred in the part other than fuser.
l If the paper is not wrinkled, the wrinkle occurred in the fuser.
Values:
Pitch Configuration Chart
Prints the chart to confirm the pitch in A4 or Letter.
Ghost Configuration Chart
Prints the chart to confirm the ghost in A4 or Letter.
4 Colors Configuration Chart
Prints the chart to confirm the gray scale for four color printing in A4 or Letter.
Prints the chart to confirm the binding in A4 or Letter.
Prints the chart to confirm the alignment in A4 or Letter.
PHD Refresh Configuration Chart
Prints the chart to confirm the light fatigue of the PHD (Print Head Device) unit in A4 or Letter.
Main Motor Operation Check*
Checks the operation of the main motor.
Fuser Motor Operation Check
Checks the operation of the fuser motor.
Feed Roll Operation Check*
1
Checks the operation of the separatro roller.
REGI CLUTCH Operation Check
Checks the operation of REGI CLUTCH.
Dispense Motor Check(Yellow)
Checks the operation of the dispense motor for each toner cartridge.
Dispense Motor Check(Magenta)
Dispense Motor Check(Cyan)
Dispense Motor Check(Black)
Plays the sound the selected motor makes when it runs normally.
*
1
When performing the feed roll operation check, remove the paper tray from the printer.
Specifies the size of paper.