Clearing Paper Jams From the Single Sheet Feeder
1. Pull the jammed paper out of the single sheet feeder. If no jammed paper can be found or it is hard to remove the paper, go to the next step to remove
the jammed paper from the inside of the printer.
2. Remove the tray 1 from the printer, and then pull out the jammed paper remaining inside the printer. If no jammed paper can be found or it is hard to
remove the paper, go to the next step to remove the jammed paper from the inside of the printer.
3.
Open the front cover by pushing the button (right side) and remove the jammed paper. Then, confirm that there are no scraps of paper remaining inside
CAUTION: Do not attempt to clear any jams using tools or instruments. This may permanently damage the printer.
NOTICE: To protect the drums of the toner cartridges against bright light, close the front cover within three minutes. If the front cover remains open for
more than three minutes, print quality may deteriorate.
NOTE: To resolve the error displayed on the operator panel, you must clear all print media from the print media path.
To Next Page
Loading...
Need help?
General
