10Mbps, Half Duplex-Forces the printer to try to connect to the network only at 10Mbps, Half
Duplex.
10Mbps, Full Duplex-Forces the printer to try to connect to the network only at 10Mbps, Full
Duplex.
100Mbps, Half Duplex-Forces the printer to try to connect to the network only at 100Mbps,
Half Duplex.
100Mbps, Full Duplex-Forces the printer to try to connect to the network only at 100Mbps,
Full Duplex.
Parallel Menu
Use the Parallel menu to change printer settings on jobs sent through a parallel port.
NPA Mode
Use this setting to: send print jobs to the printer and query printer status information simultaneously.
Values:
Off
On
Auto (factory default)
Protocol
Use this setting to: receive information at a much higher transmission rate if your printer is set to
Fastbytes (if your computer supports Fastbytes) or receive information at a normal transmission rate if your
printer is set to Standard.
Values:
Standard
Fastbytes (factory default)
Parallel Mode 2
Use this setting to: determine whether the parallel port data is sampled on the leading (On) or trailing
(Off) edge of strobe.
To Next Page